Promag CON-485 Series Instructions d'exploitation télécharger pdf (Page 11)

Memo-Graph S 3 Installation

Endress+Hauser 11

2.2 Scope of delivery

• Device (with screw plug-in terminals for mains and signal connection, according to your order)

• 2 jack screws

• 1 screwdriver, blade width of 2.5 mm

• PC operating and configuration software on CD-ROM

• Delivery note

• These Operating Instructions

• Memory card / floppy disk, in case it has been ordered

Anything missing? Then please inform your supplier.

2.3 Certificates and approvals

An overview of all certificates and approvals can be found in the Technical Data → Chapter 10.10

3 Installation

3.1 Incoming acceptance, transport, storage

3.1.1 Incoming acceptance

After receiving the goods, check the following points:

• Is the packaging or the contents damaged?

• Is the delivery complete? Compare the goods delivered with what you ordered.

3.1.2 Transport and storage

Observe the following points:

• The device must be packed in shockproof packaging for storage (and transport). The original

packaging offers the best protection for this.

• The permitted storage temperature is −20 to +70 °C (preferably +20 °C).

3.2 Installation conditions

Working temperature range:

0 to 50 °C, max. 57 % rel. moisture without condensation.

Caution!

• To avoid heat accumulation, please always ensure that the device is sufficiently cooled.

• Maintain distance from heavily magnetic fields (compare with Chapter 10 “Technical data”,

interference immunity )

• Environment at front in accordance with device ingress protection IP 54 (die-cast front with

closed door) or IP 65 / NEMA 4X (stainless steel front)

• The corresponding ingress protection is only guaranteed when the control panel seal is correctly

mounted.

3.2.1 Dimensions

The dimensions of the “Safety Data Manager” can be found in Chapter 10 “Technical data”.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 97 98

Pas de commentaire

Promag CON-485 Series Instructions d'exploitation Page 11